Home Page Products Education Papers Projects Support Gallery Download سايت فارسي
 

 

Safety instructions (Electrospinning Systems)

Warning and Safety instructions

  • To avoid the risk of accidents and damage to the machine, please read instructions carefully before using it for the first time. They contain important information on its installation, safety, use and maintenance. Keep these instructions in a safe place and ensure that new users are familiar with the content. Pass them on to any future owner.

  • Before setting up the machine, check it for any externally visible damage. Do not install or use a damaged machine.

  • Before connecting the machine, ensure that the connection data on the data plate (voltage and frequency) match the mains electricity supply. If in any doubt, consult a qualified electrician.

  • The electrical safety of this machine can only be guaranteed when correctly earthed. It is most important that this basic safety requirement is observed and regularly tested, and where there is any doubt the household wiring system should be inspected by a qualified electrician. The manufacturer cannot be held liable for the consequences of an inadequate earthing system (e.g. electric shock).

  • Do not connect the Electrospinning machine to the mains electricity supply by an extension lead. Extension leads do not guarantee the required safety of the machine (e.g. danger of overheating).

  • Faulty components must only be replaced by Fnm co original spare parts. Only when these parts are fitted can the safety standards of the machine be guaranteed.

  • Make sure the high voltage cable properly connect to nozzles. Connection of "high voltage" cable to every part of the device (other than nozzles) will cause failure of electronic systems.

  • Before starting the machine, be sure high voltage power supply is off.

 

How to fix defects and potential problems

 

 
   
 

HOME | About us | Products | Projects | Gallery | Download | Contact